OS10 Enterprise Edition User Guide Release 10.4.0E(R3)

PDF

policy-map

Enters QoS POLICY-MAP mode and creates or modifies a QoS policy-map.

Syntax
policy-map policy-map-name [type {qos | queuing | control-plane | application | network-qos }]
Parameters
  • policy-map-name — Enter a class name for the policy-map (up to 32 characters).
  • type — Enter the policy-map type.
    • qos — Create a qos policy-map type.
    • queuing — Create a queueing policy-map type.
    • control-plane — Create a control-plane policy-map type.
    • application — Create an application policy-map type.
    • network-qos — Create a network-qos policy-map type.
Defaults
qos = class-map type and match-any = class-map filter
Command Mode
CONFIGURATION
Usage Information
The no version of this command deletes a policy-map.
Example
OS10(config)# policy-map p1
Example (Queuing)
OS10(config)# policy-map type queuing p1
Supported Releases
10.2.0E or later

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\