OS10 Enterprise Edition User Guide Release 10.4.0E(R3)

PDF

policy route-map

Assigns a route-map for IPv4 or IPV6 policy-based routing to the interface.

Syntax
{ip | ipv6} policy route-map [ map-name]
Parameters
map-name —Enter the name of a configured route-map (up to 140 characters).
Defaults
Not configured
Command Mode
INTERFACE
Usage Information
None
Example
OS10(config)# interface ethernet 1/1/1
                                       OS10(conf-if-eth1/1/1)# ip policy route-map map1
                                    
Supported Releases
10.3.0E or later

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\