OS10 Enterprise Edition User Guide Release 10.4.0E(R3)

PDF

priority-flow-control mode

Enables or disables priority flow-control mode on an interface.

Syntax
priority-flow-control mode [on]
Parameters
  • on — (Optional) Enables priority flow-control mode.
Default
Disabled
Command Mode
INTERFACE
Usage Information
Before enabling priority flow-control on a interface, verify a matching network-qos type policy is configured with the pfc-cos value for an interface. Use this command to disable priority flow-control if you are not using a network-qos type policy for an interface. The no version of this command returns the value to the default.
Example
OS10(conf-if-eth1/1/2)# priority-flow-control mode on
Supported Releases
10.3.0E or later

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\