OS10 Enterprise Edition User Guide Release 10.4.0E(R3)

PDF

priority

Assigns a VRRP priority value for the VRRP group. The VRRP protocol uses this value during the master election process.

Syntax
priority number
Parameters
number — Enter a priority value (1 to 254).
Default
100
Command Mode
INTERFACE-VRRP
Usage Information
To guarantee that a VRRP group becomes master, configure the VRRP group’s virtual address with same IP address as the interface’s primary IP address, and change the priority of the VRRP group to 255. If you set this command to 255 and the virtual-address is not equal to the interface’s primary IP address, the system displays an error message. The no version of this command resets the value to the default (100).
Example
OS10(conf-eth1/1/5-vrid-254)# priority 200
                                       
                                    
Supported Releases
10.2.0E or later

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\