OS10 Enterprise Edition User Guide Release 10.4.0E(R3)

PDF

priority

Sets the scheduler as a strict-priority.

Syntax
priority
Parameters
None
Default
WDRR — when priority is mentioned, it moves to SP with default level 1
Command Mode
POLICY-MAP-CLASS-MAP
Usage Information
If you use this command, bandwidth is not allowed. Only the egress QoS policy type supports this command.
Example
OS10(conf-pmap-que)# priority
Supported Releases
10.2.0E or later

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\