OS10 Enterprise Edition User Guide Release 10.4.0E(R3)

PDF

qos-group dot1p

Configures a dot1p trust map to the traffic class.

Syntax
qos-group tc-list [dot1p values]
Parameters
  • qos-group tc-list — Enter the traffic single value class ID (0 to 7).
  • dot1p values — (Optional) Enter either single, comma-delimited, or a hyphenated range of dot1p values (0 to 7).
Default
0
Command Mode
TRUST-MAP
Usage Information
If the trust map does not define dot1p values to any traffic class, those flows are mapped to the default traffic class (0). If some of the dot1p values are already mapped to an existing traffic class, you will receive an error. You should have a 1:1 dot1p to traffic class mapping for PFC-enabled CoS values. You should also have a common dot1p trust map for all interfaces using DCB. The no version of this command returns the value to the default.
Example
OS10(conf-tmap-dot1p-qos)# qos-group 5 dot1p 5
Supported Releases
10.3.0E or later

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\