OS10 Enterprise Edition User Guide Release 10.4.0E(R3)

PDF

qos-group dscp

Configures a dscp trust map to the traffic class.

Syntax
qos-group tc-list [dscp values]
Parameters
  • qos-group tc-list — Enter the traffic single value class ID (0 to 7).
  • dscp values — (Optional) Enter either single, comma-delimited, or a hyphenated range of dscp values (0 to 63).
Default
0
Command Mode
TRUST-MAP
Usage Information
If the trust map does not define dscp values to any traffic class, those flows are mapped to the default traffic class (0). If some of the dscp values are already mapped to an existing traffic class, you will receive an error. The no version of this command returns the value to the default.
Example
OS10(conf-tmap-dscp-qos)# qos-group 5 dscp 42
Supported Releases
10.3.0E or later

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\