OS10 Enterprise Edition User Guide Release 10.4.0E(R3)

PDF

qos-map traffic-class

Creates user-defined trust map for queue mapping.

Syntax
qos-map traffic-class map-name
Parameters
map-name — Enter the name of the queue trust map (up to 32 characters).
Default
Not configured
Command Mode
CONFIGURATION
Usage Information
The traffic class will route all traffic to the mapped queue if applied on the interface- or system-level. The no version of this command returns the value to the default.
Example
OS10(config)# qos-map traffic-class queue-map1
                                       OS10(config-qos-map)# queue 1 qos-group 5
                                       OS10(config-qos-map)# queue 2 qos-group 6
                                       OS10(config-qos-map)# queue 3 qos-group 7
                                       OS10(config-qos-map)#
                                    
Supported Releases
10.3.0E or later

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\