OS10 Enterprise Edition User Guide Release 10.4.0E(R3)

PDF

queue qos-group

Configures a dot1p traffic class to a queue.

Syntax
queue number [qos-group dot1p-values]
Parameters
  • queue number — Enter the traffic single value queue ID (0 to 7).
  • qos-group dot1p-values — (Optional) Enter either single, comma-delimited, or a hyphenated range of dot1p values (0 to 7).
Default
0
Command Mode
TRUST-MAP
Usage Information
If the trust map does not define traffic class values to a queue, those flows are mapped to the default queue (0). If some of the traffic class values are already mapped to an existing queue, you will receive an error. The no version of this command returns the value to the default.
Example
OS10(conf-tmap-tc-queue-qos)# queue 2 qos-group 5
Supported Releases
10.3.0E or later

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\