OS10 Enterprise Edition User Guide Release 10.4.0E(R3)

PDF

random-detect (interface)

Assigns a WRED profile to the specified interface.

Syntax
random-detect wred-profile
Parameters
wred-profile — Enter the name of an existing WRED profile.
Default
Not configured
Command Mode
INTERFACE
Usage Information
The no version of this command removes the WRED profile from the interface.
Example
OS10(config)# interface ethernet 1/1/1
                                       OS10(conf-if-eth1/1/1)# random-detect test_wred
                                       
                                    
Supported Releases
10.4.0E(R1) or later

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\