OS10 Enterprise Edition User Guide Release 10.4.0E(R3)

PDF

Reload system image

Reboot the system manually using the reload command in EXEC mode. You are prompted to confirm the operation.
OS10# reload
                                    
                                    System configuration has been modified. Save? [yes/no]:yes
                                    
                                    Saving system configuration
                                    
                                    Proceed to reboot the system? [confirm yes/no]:yes
                                 
To configure the OS10 image loaded at the next system boot, enter the boot system command in EXEC mode.
boot system {active | standby}
  • Enter active to load the primary OS10 image stored in the A partition.
  • Enter standby to load the secondary OS10 image stored in the B partition.

Set next boot image

OS10# boot system standby
                                 OS10# show boot 
                                 Current system image information:
                                 ===================================
                                 Type       Boot Type   Active          Standby         Next-Boot
                                 -------------------------------------------------------------------
                                 Node-id 1  Flash Boot  [A] 10.2.9999E  [B] 10.2.9999E  [B] standby
                              

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\