OS10 Enterprise Edition User Guide Release 10.4.0E(R3)

PDF

remark

Specifies an ACL entry description.

Syntax
remark [ remark-number] [ description]
Parameters
  • remark-number — (Optional) Enter a remark number, from 1 to 16777214 for IPv4, IPv6, and MAC.
  • description — (Optional) Enter a description. A maximum of 80 characters.
Default
Not configured
Command Mode
IPV4-ACL
Usage Information
Use different sequence numbers for the remark and the ACL rule. Configure up to 16777214 remarks for a given IPv4, IPv6, or MAC.
Example
OS10(conf-ipv4-acl)# remark 10 Deny rest of the traffic
                                       OS10(conf-ipv4-acl)# remark 5 Permit traffic from XYZ Inc.
                                       
                                    
Supported Releases
10.2.0E or later

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\