OS10 Enterprise Edition User Guide Release 10.4.0E(R3)

PDF

router-id

Configures a fixed router ID for the OSPFv3 process.

Syntax
router-id ip-address
Parameters
ip-address — Enter the IP address of the router as the router ID.
Default
Not configured
Command Mode
ROUTER-OSPFv3
Usage Information
Configure an arbitrary value in the IP address format for each router. Each router ID must be unique. Use the fixed router ID for the active OSPFv3 router process. Changing the router ID brings down the existing OSPFv3 adjacency. The new router ID becomes effective immediatley. The no version of this command disables the router ID configuration.
Example
OS10(config)# router ospfv3 10
                                       OS10(config-router-ospfv3-100)# router-id 10.10.1.5
                                       
                                    
Supported Releases
10.3.0E or later

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\