OS10 Enterprise Edition User Guide Release 10.4.0E(R3)

PDF

scale-profile vlan

Configures the L2 VLAN scale profile on a switch.

Syntax
scale-profile vlan
Parameters
None
Defaults
Not configured
Command Mode
CONFIGURATION
Usage Information
Use the VLAN scale profile when you scale the number of VLANs so that less memory is consumed. Enable the scale profile before you configure VLANs on the switch. The scale profile globally applies L2 mode on all VLANs you create and disables L3 transmission. The no version of the command disables L2 VLAN scaling. To enable L3 routing traffic on a VLAN, use the mode L3 command.
Example
OS10(config)# scale-profile vlan
Supported Releases
10.4.0E(X2) or later

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\