OS10 Enterprise Edition User Guide Release 10.4.0E(R3)

PDF

sender-side-loop-detection

Enables the sender-side loop detection process for a BGP neighbor.

Syntax
sender-side-loop-detection
Parameters
None
Default
Enabled
Command Mode
ROUTER-BGP-NEIGHBOR-AF
Usage Information
This command helps detect routing loops, based on the AS path before it starts advertising routes. To configure a neighbor to accept routes use the neighbor allowas-in command. The no version of this command disables sender-side loop detection for that neighbor.
Example (IPv4)
OS10(conf-router-bgp-102)# neighbor 3.3.3.1
                                       OS10(conf-router-neighbor)# address-family ipv4 unicast 
                                       OS10(conf-router-bgp-neighbor-af)# sender-side-loop-detection
                                    
Example (IPv6)
OS10(conf-router-bgp-102)# neighbor 32::1
                                       OS10(conf-router-neighbor)# address-family ipv6 unicast 
                                       OS10(conf-router-bgp-neighbor-af)# no sender-side-loop-detection  
                                    
Supported Releases
10.3.0E or later

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\