OS10 Enterprise Edition User Guide Release 10.4.0E(R3)


seq deny (IPv6)

Assigns a sequence number to deny IPv6 addresses while creating the filter.

seq sequence-number deny [ protocol-number icmp | ip | tcp | udp] [A::B | A::B/x | any | host ipv6-address] [A::B | A::B/x | any | host ipv6-address] [capture | count [byte] | dscp value | fragment]
  • sequence-number — Enter the sequence number to identify the route-map for editing and sequencing number, from 1 to 16777214.
  • protocol-number — (Optional) Enter the protocol number, from 0 to 255.
  • icmp — (Optional) Enter the ICMP address to deny.
  • ip — (Optional) Enter the IP address to deny.
  • tcp — (Optional) Enter the TCP address to deny.
  • udp — (Optional) Enter the UDP address to deny.
  • A::B — Enter the IPv6 address in hexadecimal format separated by colons.
  • A::B/x — Enter the number of bits that must match the IPv6 address.
  • any — (Optional) Determine route types:
    • capture — (Optional) Enter to capture packets the filter processes.
    • count — (Optional) Enter to count packets the filter processes.
    • byte — (Optional) Enter to count bytes the filter processes.
    • dscp value — (Optional) Enter to deny a packet based on the DSCP values, from 0 to 63.
    • fragment — (Optional) Enter to use ACLs to control packet fragments.
  • host ipv6-address — (Optional) Enter to use an IPv6 host address only.
Not configured
Command Mode
Usage Information
OS10 cannot count both packets and bytes; when you enter the count byte options, only bytes increment. The no version of this command removes the filter, or use the no seq sequence-number command if you know the filter’s sequence number.
OS10(config)# ipv6 access-list ipv6test
                                       OS10(conf-ipv6-acl)# seq 5 deny ipv6 any any capture session 1 count
Supported Releases
10.2.0E or later

Rate this content

Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\