OS10 Enterprise Edition User Guide Release 10.4.0E(R3)


seq deny (MAC)

Assigns a sequence number to a deny filter in a MAC access list while creating the filter.

seq sequence-number deny {nn:nn:nn:nn:nn:nn [00:00:00:00:00:00] | any} {nn:nn:nn:nn:nn:nn [00:00:00:00:00:00] | any} [ protocol-number | capture | cos | count [byte] | vlan]
  • sequence-number — Enter the sequence number to identify the route-map for editing and sequencing number, from 1 to 16777214.
  • nn:nn:nn:nn:nn:nn — Enter the source MAC address.
  • 00:00:00:00:00:00 — (Optional) Enter which bits in the MAC address must match. If you do not enter a mask, a mask of 00:00:00:00:00:00 applies.
  • any — (Optional) Set all routes which are subject to the filter:
    • protocol-number — Protocol number identified in the MAC header, from 600 to ffff.
    • capture — (Optional) Capture packets the filter processes.
    • cos — (Optional) CoS value, from 0 to 7.
    • count — (Optional) Count packets the filter processes.
    • byte — (Optional) Count bytes the filter processes.
    • vlan — (Optional) VLAN number, from 1 to 4093.
Not configured
Command Mode
Usage Information
OS10 cannot count both packets and bytes; when you enter the count byte options, only bytes increment. The no version of this command removes the filter, or use the no seq sequence-number command if you know the filter’s sequence number.
OS10(config)# mac access-list macacl
                                       OS10(conf-mac-acl)# seq 10 deny 00:00:00:00:11:11 00:00:11:11:11:11 any cos 7
                                       OS10(conf-mac-acl)# seq 20 deny 00:00:00:00:11:11 00:00:11:11:11:11 any vlan 2
Supported Releases
10.2.0E or later

Rate this content

Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\