OS10 Enterprise Edition User Guide Release 10.4.0E(R3)


seq deny

Assigns a sequence number to deny IP addresses while creating the filter.

seq sequence-number deny [ protocol-number | icmp | ip | tcp | udp] [A.B.C.D | A.B.C.D/x | any | host ip-address] [A.B.C.D | A.B.C.D/x | any | host ip-address] [capture | count [byte] | dscp value | fragment]
  • sequence-number — Enter the sequence number to identify the ACL for editing and sequencing number, from 1 to 16777214.
  • protocol-number — (Optional) Enter the protocol number, from 0 to 255.
  • icmp — (Optional) Enter the ICMP address to deny.
  • ip — (Optional) Enter the IP address to deny.
  • tcp — (Optional) Enter the TCP address to deny.
  • udp — (Optional) Enter the UDP address to deny.
  • A.B.C.D — Enter the IP address in dotted decimal format.
  • A.B.C.D/x — Enter the number of bits that must match the dotted decimal address.
  • any — (Optional) Set all routes which are subject to the filter:
    • capture — (Optional) Capture packets the filter processes.
    • count — (Optional) Count packets the filter processes.
    • byte — (Optional) Count bytes the filter processes.
    • dscp value — (Optional) Permit a packet based on the DSCP values, from 0 to 63.
    • fragment — (Optional) Use ACLs to control packet fragments.
  • host ip-address — (Optional) Enter the IP address to use a host address only.
Not configured
Command Mode
Usage Information
OS10 cannot count both packets and bytes; when you enter the count byte options, only bytes increment. The no version of this command removes the filter, or use the no seq sequence-number command if you know the filter’s sequence number.
OS10(config)# ip access-list testflow
                                       OS10(conf-ipv4-acl)# seq 10 deny tcp any any capture session 1
Supported Releases
10.2.0E or later

Rate this content

Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\