OS10 Enterprise Edition User Guide Release 10.4.0E(R3)

PDF

seq permit (MAC)

Assigns a sequence number to permit MAC addresses while creating a filter.

Syntax
seq sequence-number permit {nn:nn:nn:nn:nn:nn [00:00:00:00:00:00] | any} {nn:nn:nn:nn:nn:nn [00:00:00:00:00:00] | any} [ protocol-number | capture | cos | count [byte] | vlan]
Parameters
  • sequence-number — Enter the sequence number to identify the route-map for editing and sequencing, from 1 to 16777214.
  • nn:nn:nn:nn:nn:nn — Enter the MAC address of the network from or to which the packets were sent.
  • 00:00:00:00:00:00 — (Optional) Enter which bits in the MAC address must match. If you do not enter a mask, a mask of 00:00:00:00:00:00 applies.
  • any — (Optional) Set all routes to be subject to the filter:
    • protocol-number — (Optional) Enter the protocol number identified in the MAC header, from 600 to ffff.
    • capture — (Optional) Enter the capture packets the filter processes.
    • cos — (Optional) Enter the CoS value, from 0 to 7.
    • count — (Optional) Enter the count packets the filter processes.
    • byte — (Optional) Enter the count bytes the filter processes.
    • vlan — (Optional) Enter the VLAN number, from 1 to 4093.
Default
Not configured
Command Mode
MAC-ACL
Usage Information
OS10 cannot count both packets and bytes; when you enter the count byte options, only bytes increment. The no version of this command removes the filter, or use the no seq sequence-number command if you know the filter’s sequence number.
Example
OS10(config)# mac access-list macacl
                                       OS10(conf-mac-acl)# seq 10 permit 00:00:00:00:11:11 00:00:11:11:11:11 any cos 7
                                       OS10(conf-mac-acl)# seq 20 permit 00:00:00:00:11:11 00:00:11:11:11:11 any vlan 2
                                       
                                    
Supported Releases
10.2.0E or later

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\