OS10 Enterprise Edition User Guide Release 10.4.0E(R3)

PDF

service-policy

Configures the input and output service policies.

Syntax
service-policy {input | output} [type {qos | queuing | network-qos}] policy-map-name
Parameters
  • input — Enter to assign a QoS policy to the interface input.
  • output — Enter to assign a QoS policy to the interface output.
  • qos — Enter to assign a qos type policy-map.
  • queuing — Enter to assign the queuing type policy-map.
  • network-qos — Enter to assign the network-qos type policy-map.
  • policy-map-name — Enter the policy-map name (up to 32 characters).
Default
Not configured
Command Mode
INTERFACE
Usage Information
Attach only one policy-map to the interface input and output for each qos and queuing policy-map type. You can attach four service-policies to the system QoS — one each for qos, queueing, and network-qos type policy-maps. When you configure service policies at the interface-level and system-level, the interface-level policy takes precedence over the system-level policy.
Example
OS10(conf-if-eth1/1/7)# service-policy input type qos p1
Supported Releases
10.2.0E or later

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\