OS10 Enterprise Edition User Guide Release 10.4.0E(R3)

PDF

Set address to match route-map

You can set an IPv4 or IPv6 address to match a route-map.

  1. Enter the IPv4 or IPv6 address to match and specify the access-list name in Route-Map mode.
    match {ip | ipv6} address 
                                           access-list-name
                                        
  2. Set the next-hop IP address in Route-Map mode.
    set {ip | ipv6} next-hop 
                                           ip-address
                                        
Apply match parameters to IPv4 route-map
OS10(conf-route-map)# route-map map1
                                    OS10(conf-route-map)# match ip address acl5
                                 
Apply match and set parameters to IPv6 route-map
OS10(conf-route-map)# route-map map1
                                    OS10(conf-route-map)# match ipv6 address acl8
                                    OS10(conf-route-map)# set ipv6 next-hop 20::20
                                 

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\