OS10 Enterprise Edition User Guide Release 10.4.0E(R3)

PDF

set comm-list add

Add communities in the specified list to the COMMUNITY attribute in a matching inbound or outbound BGP route.

Syntax
set comm-list { community-list-name} add
Parameters
community-list-name — Enter the name of an established community list (up to 140 characters).
Defaults
None
Command Mode
ROUTE-MAP
Usage Information
In a route map, use this set command to add a list of communities that pass a permit statement to the COMMUNITY attribute of a BGP route sent or received from a BGP peer. Use the set comm-list delete command to delete a community list from a matching route.
Example
OS10(config)# route-map bgp
                                       OS10(conf-route-map)# set comm-list comlist1 add
                                    
Supported Releases
10.4.0E(R1) or later

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\