OS10 Enterprise Edition User Guide Release 10.4.0E(R3)

PDF

set community

Sets the community attribute in BGP updates.

Syntax
set community {none | community-number}
Parameters
  • none — Enter to remove the community attribute from routes meeting the route map criteria.
  • community-number — Enter the community number in aa:nn format, where aa is the AS number (2 bytes) and nn is a value specific to that AS.
Default
Not configured
Command Mode
ROUTE-MAP
Usage Information
The no version of this command deletes a BGP COMMUNITY attribute assignment.
Example
OS10(config)# route-map bgp
                                       OS10(conf-route-map)# set community none
                                    
Supported Releases
10.3.0E or later

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\