OS10 Enterprise Edition User Guide Release 10.4.0E(R3)


set dscp

Sets the drop precedence for incoming packets based on their DSCP value and color map profile.

set dscp dscp-value [color {red | yellow}]
  • dscp-value — Enter a DSCP value (0 to 63).
  • color — (Optional) — Enter to apply a color map profile.
  • red — (Optional) Enter to mark the packets to drop.
  • yellow — (Optional) Enter to mark the packets to deliver to the egress queue.
Not configured
Command Mode
Usage Information
The QoS ingress QoS policy type only supports this command. Packets marked as color yellow deliver to the egress queue, then the egress queue transmits the packets with the available bandwidth. If bandwidth is not available, the packets drop. All packets marked as color red drop. When class-map type is qos, the qos-group corresponds to data queues 0 to 7.
OS10(conf-pmap-c-qos)# set dscp 10
Supported Releases
10.2.0E or later

Rate this content

Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\