OS10 Enterprise Edition User Guide Release 10.4.0E(R3)

PDF

set extcomm-list add

Add communities in the specified list to the EXT COMMUNITY attribute in a matching inbound or outbound BGP route.

Syntax
set extcomm-list extcommunity-list-name add
Parameter
extcommunity-list-name — Enter the name of an established extcommunity list (up to 140 characters).
Defaults
None
Command Mode
ROUTE-MAP
Usage Information
In a route map, use this set command to add an extended list of communities that pass a permit statement to the EXT COMMUNITY attribute of a BGP route sent or received from a BGP peer. Use the set extcomm-list delete command to delete an extended community list from a matching route.
Example
OS10(config)# route-map bgp
                                       OS10(conf-route-map)# set extcomm-list TestList add
                                    
Supported Releases
10.4.0E(R1) or later

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\