OS10 Enterprise Edition User Guide Release 10.4.0E(R3)

PDF

set next-hop

Sets an IPv4 or IPv6 next-hop address for policy-based routing.

Syntax
set {ip | ipv6} next-hop address
Parameters
address — Enter the next-hop IPv4 or IPv6 address.
Defaults
Not configured
Command Mode
ROUTE-MAP
Usage Information
None
Example
OS10(conf-route-map)# set ip next-hop 10.10.10.10
Supported Releases
10.3.0E or later

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\