OS10 Enterprise Edition User Guide Release 10.4.0E(R3)

PDF

set next-hop

Sets an IPv4 or IPv6 address as the next-hop.

Syntax
set {ip | ipv6} next-hop ip-address
Parameters
ip-address — Enter the IPv4 or IPv6 address for the next-hop.
Default
Not configured
Command Mode
ROUTE-MAP
Usage Information
If you apply a route-map with the set next-hop command in ROUTER-BGP mode, it takes precedence over the next-hop-self command entered in ROUTER-NEIGHBOR mode. In a route-map configuration, to configure more than one next-hop entry, enter multiple set {ip | ipv6} next-hop commands. When you apply a route-map for redistribution or route updates in ROUTER-BGP mode, configure only one next-hop. Configure multiple next-hop entries only in a route-map used for other features. The no version of this command deletes the setting.
Example
OS10(conf-route-map)# set ip next-hop 10.10.10.2
                                       
                                    
Example (IPv6)
OS10(conf-route-map)# set ipv6 next-hop 11AA:22CC::9
                                       
                                    
Supported Releases
10.2.0E or later

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\