OS10 Enterprise Edition User Guide Release 10.4.0E(R3)

PDF

set weight

Set the BGP weight for the routing table.

Syntax
set weight weight
Parameters
weight — Enter a number as the weight the route uses to meet the route map specification, from 0 to 65535.
Default
Default router-originated is 32768 — all other routes are 0.
Command Mode
ROUTE-MAP
Usage Information
The no version of the command deletes the set clause from the route map.
Example
OS10(conf-route-map)# set weight 200
                                       
                                    
Supported Releases
10.2.0E or later

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\