OS10 Enterprise Edition User Guide Release 10.4.0E(R3)

PDF

sflow enable

Enables sFlow on a specific interface or globally on all interfaces.

Syntax
sflow enable [all-interfaces]
Parameters
all-interfaces — (Optional) Enter to enable sFlow globally.
Default
Disabled
Command Mode
CONFIGURATION
Usage Information

The no version of this command to disables sFlow.

Example (interface)
OS10(config)# sflow enable
                                       OS10(config)# interface ethernet 1/1/1
                                       OS10(conf-if-eth1/1/1)# sflow enable
                                    
Example (interface range)
OS10(config)# sflow enable
                                       OS10(config)# interface range ethernet 1/1/1-1/1/10
                                       OS10(conf-range-eth1/1/1-1/1/10)# sflow enable
                                    
Example (port-channel)
OS10(config)# sflow enable 
                                       OS10(config)# interface range port-channel 1-10
                                       OS10(conf-range-po-1-10)# sflow enable
                                    
Supported Releases
10.3.0E or later

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\