OS10 Enterprise Edition User Guide Release 10.4.0E(R3)

PDF

sflow polling-interval

Sets the sFlow polling interval.

Syntax
sflow polling-interval interval-value
Parameter
interval-value — Enter the interval value in sections, from 10 to 300. The default is 30.
Defaults
30
Command Mode
CONFIGURATION
Usage Information

The polling interval for an interface is the number of seconds between successive samples of counters sent to the collector. You can configure the duration for polled interface statistics. The no version of the command resets the interval time to the default value.

Example
OS10(conf)# sflow polling-interval 200
Supported Releases
10.3.0E or later

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\