OS10 Enterprise Edition User Guide Release 10.4.0E(R3)

PDF

shape

Shapes the outgoing traffic rate.

Syntax
shape {min {kbps | mbps | pps} min-value [ burst-size]} {max {kbps | mbps | pps} max-value [ max-burst-size]}
Parameters
  • min — Enter the minimum committed rate in unit (kbps, mbps , or pps).
  • kbps — Enter the committed rate unit in kilobits per second (0 to 40000000).
  • mbps — Enter the committed rate unit in megabits per second (0 to 40000).
  • pps — Enter the committed rate unit in packets per second (1 to 268000000).
  • burst-size — Enter the burst size in kilobytes per packet (0 to 10000 or 1 to 1073000).
  • max — Enter the maximum peak rate in kbps, mbps , or pps.
  • max-burst-size — Enter the burst size in kilobytes per packets (0 to 10000 or 1 to 1073000).
Default
Maximum burst size is 50 kb or 200 packets
Command Mode
POLICY-MAP-CLASS-MAP
Usage Information
Only the ingress QoS policy type supports this command. You must enter both the minimum and maximum values. If you enter the rate value in pps, the burst provided is in packets. If you enter the rate in kbps or mbps, the burst is provided in kb. If you enter the minimum rate in pps, you must also enter the maximum rate in pps.
Example
OS10(conf-pmap-c-que)# shape min kbps 11 max kbps 44
                                       
                                    
Supported Releases
10.2.0E or later

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\