OS10 Enterprise Edition User Guide Release 10.4.0E(R3)

PDF

show interface priority-flow-control

Displays the priority flow-control, operational status, CoS bitmap, and statistics per port.

Syntax
show interface ethernet 1/1/1 priority-flow-control [details]
Parameters
details — (Optional) Displays all priority flow control information for an interface.
Default
Not configured
Command Mode
EXEC
Usage Information
None
Example (Details)
OS10# show interface priority-flow-control details
                                       
                                       TenGig 1/1:
                                       Admin Mode: On
                                       OperStatus: On
                                       PFC Priorites: 0,4,7
                                       Total Rx PFC Frames: 300
                                       Total Tx PFC Frames: 200
                                       Cos     Rx     Tx
                                       -----------------------
                                       0       0      0
                                       1       0      0
                                       2       0      0
                                       3       300    200
                                       4       0      0
                                       5       0      0
                                       6       0      0
                                       7       0      0
                                    
Supported Releases
10.3.0E or later

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\