OS10 Enterprise Edition User Guide Release 10.4.0E(R3)

PDF

show interface

Displays interface information.

Syntax
show interface [ type]
Parameters
interface type — Enter the interface type:
  • phy-eth node/slot/port[:subport] — Display information about physical ports connected to the interface.
  • status — Display interface status.
  • ethernet node/slot/port[:subport] — Display Ethernet interface information.
  • loopback id — Display loopback IDs (0 to 16383).
  • mgmt node/slot/port — Display Management interface information.
  • null — Display null interface information.
  • port-channel id-number — Display port channel interface IDs (1 to 128).
  • vlan vlan-id — Display the VLAN interface number (1 to 4093).
Default
Not configured
Command Mode
EXEC
Usage Information
Use the do show interface command to view interface information from other command modes.
Example
OS10# show interface
                                       Ethernet 1/1/2 is up, line protocol is up
                                       Hardware is Dell EMC Eth, address is 00:0c:29:54:c8:57
                                       Current address is 00:0c:29:54:c8:57
                                       Pluggable media present, QSFP-PLUS type is QSFP_40GBASE_CR4_1M
                                       Wavelength is 64
                                       Receive power reading is 0.0
                                       Interface index is 17305094
                                       Internet address is not set
                                       Mode of IPv4 Address Assignment: not set
                                       Interface IPv6 oper status: Enabled
                                       Link local IPv6 address: fe80::20c:29ff:fe54:c857/64
                                       Global IPv6 address: 2::1/64
                                       MTU 1532 bytes, IP MTU 1500 bytes
                                       LineSpeed 40G, Auto-Negotiation on
                                       FEC is auto, Current FEC is off
                                       Flowcontrol rx off tx off
                                       ARP type: ARPA, ARP Timeout: 60
                                       Last clearing of "show interface" counters: 00:40:14
                                       Queuing strategy: fifo
                                       Input statistics:
                                       0 packets, 0 octets
                                       0 64-byte pkts, 0 over 64-byte pkts, 0 over 127-byte pkts
                                       0 over 255-byte pkts, 0 over 511-byte pkts, 0 over 1023-byte pkts
                                       0 Multicasts, 0 Broadcasts, 0 Unicasts
                                       0 runts, 0 giants, 0 throttles
                                       0 CRC, 0 overrun, 0 discarded
                                       Output statistics:
                                       0 packets, 0 octets
                                       0 64-byte pkts, 0 over 64-byte pkts, 0 over 127-byte pkts
                                       0 over 255-byte pkts, 0 over 511-byte pkts, 0 over 1023-byte pkts
                                       0 Multicasts, 0 Broadcasts, 0 Unicasts
                                       0 throttles, 0 discarded, 0 Collisions, 0 wreddrops
                                       Rate Info(interval 299 seconds):
                                       Input 0 Mbits/sec, 0 packets/sec, 0% of line rate
                                       Output 0 Mbits/sec, 0 packets/sec, 0% of line rate
                                       Time since last interface status change: 3 weeks 1 day 20:30:38
                                       
                                       --more--
                                       
                                    
Example (port channel)
OS10# show interface port-channel 1
                                       Port-channel 1 is up, line protocol is down
                                       Address is 90:b1:1c:f4:a5:8c, Current address is 90:b1:1c:f4:a5:8c
                                       Interface index is 85886081
                                       Internet address is not set
                                       Mode of IPv4 Address Assignment: not set
                                       MTU 1532 bytes
                                       LineSpeed 0
                                       Minimum number of links to bring Port-channel up is 1
                                       Maximum active members that are allowed in the portchannel is 5 
                                       Members in this channel:
                                       ARP type: ARPA, ARP Timeout: 60
                                       
                                    
OS10# show interface port-channel summary
                                       LAG Mode Status Uptime Ports
                                       22 L2 up 20:38:08 Eth 1/1/10 (Up)
                                       Eth 1/1/11 (Down)
                                       Eth 1/1/12 (Inact)
                                       23 L2 up 20:34:32 Eth 1/1/20 (Up)
                                       Eth 1/1/21 (Up)
                                       Eth 1/1/22 (Up)
                                       
                                    
Supported Releases
10.2.0E or later

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\