OS10 Enterprise Edition User Guide Release 10.4.0E(R3)


show ip ospf asbr

Displays all the ASBR visible to OSPF.

show ip ospf [ process-id] asbr
process-id —(Optional) Displays information based on the process ID.
Not configured
Command Mode
Usage Information
You can isolate problems with external routes. External OSPF routes are calculated by adding the LSA cost to the cost of reaching the ASBR router. If an external route does not have the correct cost, this command determines if the path to the originating router is correct. ASBRs that are not in directly connected areas display. You can determine if an ASBR is in a directly connected area or not by the flags. For ASBRs in a directly connected area, E flags are set.
OS10# show ip ospf 10 asbr
                                       RouterID         Flags    Cost   Nexthop         Interface    Area
                                     E/-/-/   1       vlan3050
                                     E/-/-/   0         -             -
Supported Releases
10.2.0E or later

Rate this content

Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\