OS10 Enterprise Edition User Guide Release 10.4.0E(R3)


show ip ospf database asbr-summary

Displays information about AS boundary LSAs.

show ip ospf [ process-id] database asbr-summary
process-id —(Optional) Displays the AS boundary LSA information for a specified OSPF process ID. If you do not enter a process ID, this applies only to the first OSPF process.
Not configured
Command Mode
Usage Information
  • LS Age —Displays the LS age.
  • Options—Displays optional capabilities.
  • LS Type —Displays the Link State type.
  • Link State ID —Identifies the router ID.
  • Advertising Router —Identifies the advertising router’s ID.
  • LS Seq Number—Identifies the LS sequence number (identifies old or duplicate LSAs).
  • Checksum—Displays the Fletcher checksum of an LSA’s complete contents.
  • Length—Displays the LSA length in bytes.
  • Network Mask —Identifies the network mask implemented on the area.
  • TOS—Displays the ToS options. The only option available is zero..
  • Metric—Displays the LSA metric.
OS10# show ip ospf 10 database asbr-summary
                                       OSPF Router with ID ( (Process ID 100)
                                       Summary Asbr (Area
                                       LS age: 32
                                       Options: (No TOS-Capability, No DC)
                                       LS type: Summary Asbr
                                       Link State ID:
                                       Advertising Router:
                                       LS Seq Number: 0x80000001
                                       Checksum: 0xB595
                                       Length: 28
                                       Network Mask: /0
                                       TOS: 0 Metric: 0
Supported Releases
10.2.0E or later

Rate this content

Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\