OS10 Enterprise Edition User Guide Release 10.4.0E(R3)

PDF

show ipv6 management-route

Displays the IPv6 routes used to access the management port.

Syntax
show ipv6 management-route [all | connected | summary | static]
Parameters
  • all — (Optional) Display the IPv6 routes that the management interface uses.
  • connected — (Optional) Display only routes directly connected to the management interface.
  • summary — (Optional) Display the number of active and non-active management routes and their remote destinations.
  • static — (Optional) Display non-active management routes.
Default
Not configured
Command Mode
EXEC
Usage Information
Use this command to view the IPv6 static routes configured for the management port. Use the management route command to configure an IPv4 or IPv6 management route.
Example
OS10# show ipv6 management-route
                                       
                                       Destination    Gateway                 State
                                       -----------    -------                 -----
                                       2001:34::0/64  ManagementEthernet 1/1  Connected
                                       2001:68::0/64  2001:34::16             Active
                                    
Supported Releases
10.2.2E or later

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\