OS10 Enterprise Edition User Guide Release 10.4.0E(R3)

PDF

show ipv6 ospf interface

Displays the configured OSPFv3 interfaces. You must enable OSPFv3 to display the output.

Syntax
show ipv6 ospf interface interface
Parameters
interface — (Optional) Enter the interface information:
  • ethernet — Physical interface (1 to 48)
  • port-channel — Port-channel interface (1 to 128).
  • vlan — VLAN interface 1 to 4093).
Default
Not configured
Command Mode
EXEC
Example
OS10# show ipv6 ospf interface
                                       ethernet1/1/1 is up, line protocol is up
                                       Link Local Address fe80::20c:29ff:fe0a:d59/64, Interface ID 5
                                       Area 0.0.0.0, Process ID 200, Instance ID 0, Router ID 10.0.0.2
                                       Network Type broadcast, Cost: 1
                                       Transmit Delay is 1 sec, State BDR, Priority 1
                                       Designated Router on this network is 2.2.2.2
                                       Backup Designated router on this network is 10.0.0.2 (local)
                                       Timer intervals configured, Hello 10, Dead 40, Wait 40, Retransmit 5
                                       Neighbor Count is 1, Adjacent neighbor count is 1
                                       Adjacent with neighbor 2.2.2.2(Designated Router)
                                    
Supported Releases
10.3.0E or later

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\