OS10 Enterprise Edition User Guide Release 10.4.0E(R3)

PDF

show ipv6 ospf neighbor

Displays a list of OSPFv3 neighbors connected to the local router.

Syntax
show ipv6 ospf neighbor
Parameters
None
Default
Not configured
Command Mode
EXEC
Usage Information
  • Neighbor ID—Displays the neighbor router ID.
  • Pri—Displays the priority assigned neighbor.
  • State—Displays the OSPF state of the neighbor.
  • Dead Time—Displays the expected time until the system declares the neighbor dead.
  • Interface ID—Displays the neighbor interface ID
  • Interface—Displays the interface type, node/slot/port or number information.
Example
OS10(conf-if-eth1/1/1)# show ipv6 ospf neighbor
                                       Neighbor ID   Pri     State     Dead Time   Interface ID  Interface
                                       -------------------------------------------------------------------
                                       2.2.2.2       1       Full/DR   00:00:30    5             ethernet1/1/1
                                    
Supported Releases
10.3.0E or later

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\