OS10 Enterprise Edition User Guide Release 10.4.0E(R3)

PDF

show lacp neighbor

Displays information about LACP neighbors.

Syntax
show lacp neighbor [interface port-channel channel-number]
Parameters
  • interface port-channel — (Optional) Enter the interface port-channel.
  • channel-number — (Optional) Enter the port-channel number for the LACP neighbor (1 to 128).
Default
Not configured
Command Mode
EXEC
Usage Information
All channel groups display if you do not enter the channel-number parameter.
Example
OS10# show lacp neighbor interface port-channel 1
                                       
                                       Flags:S-Device is sending Slow LACPDUs F-Device is sending Fast LACPdus
                                       A-Device is in Active mode       P-Device is in Passive mode
                                       Port-channel port-channel1 neighbors
                                       Port: ethernet1/1/29
                                       Partner System Priority: 32768
                                       Partner System ID: 00:01:e8:8a:fd:9e 
                                       Partner Port: 178
                                       Partner Port Priority: 32768
                                       Partner Oper Key: 1
                                       Partner Oper State:aggregation synchronization collecting distributing defaulted expired
                                    
Supported Releases
10.2.0E or later

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\