OS10 Enterprise Edition User Guide Release 10.4.0E(R3)

PDF

show qos interface

Displays the QoS configuration applied to a specific interface.

Syntax
show qos interface ethernet node/slot/port[:subport]
Parameters
node/slot/port[:subport] — Enter the Ethernet interface information.
Default
Not configured
Command Mode
EXEC
Usage Information
None
Example
OS10# show qos interface ethernet 1/1/10
                                       Ethernet 1/1/10
                                       unknown-unicast-storm-control : 100 pps
                                       multicast-storm-control : 200 pps
                                       broadcast-storm-control : Disabled
                                       flow-control-rx: Enabled
                                       flow-control-tx: Disabled
                                       Service-policy (Input)(qos): p1
                                    
Supported Releases
10.2.0E or later

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\