OS10 Enterprise Edition User Guide Release 10.4.0E(R3)

PDF

show running-configuration uplink-state-group

Displays the running configuration specific to uplink-state groups.

Syntax
show running-configuration uplink-state-group [ group-id]
Parameters
group-id — Enter the uplink group ID. The running configuration of the specified group ID displays.
Default
Not configured
Command Mode
EXEC
Usage Information
None
Example
OS10# show running-configuration uplink-state-group
                                       !
                                       uplink-state-group 9
                                       downstream ethernet1/1/53
                                       downstream fibrechannel1/1/7
                                       upstream ethernet1/1/34
                                       upstream ethernet1/1/35
                                       upstream ethernet1/1/36
                                       upstream ethernet1/1/37
                                       upstream fibrechannel1/1/1
                                    
Supported Releases
10.4.0E(R3) or later

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\