OS10 Enterprise Edition User Guide Release 10.4.0E(R3)

PDF

show spanning-tree interface

Displays spanning-tree interface information for Ethernet and port-channels.

Syntax
show spanning-tree interface {ethernet node/slot/port [:subport] | port-channel port-id} [detail]
Parameters
  • ethernet node/slot/port[:subport] — Displays spanning-tree information for a physical interface.
  • port-channel port-id — Displays spanning-tree information for a port-channel number (1 to 128).
  • detail — (Optional) Displays detailed information on the interface.
Default
Not configured
Command Mode
EXEC
Usage Information
None
Example
OS10# show spanning-tree interface ethernet 1/1/6:2 detail
                                       Port 281 (ethernet1/1/6:2) of RSTP 1 is root Forwarding
                                       Port path cost 2000, Port priority 128, Port Identifier 281.128
                                       Designated root has priority 32768, address 34:17:44:55:66:7f
                                       Designated bridge has priority 32768, address 34:17:44:55:66:7f
                                       Designated port id is 151.128, designated path cost
                                       Timers: message age 0, forward delay 0, hold 0
                                       Number of transitions to forwarding state 1
                                       Link type is point-to-point by default, auto
                                       PVST Simulation is enabled by default
                                       BPDU sent 3, received 7
                                    
Supported Releases
10.2.0E or later

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\