OS10 Enterprise Edition User Guide Release 10.4.0E(R3)

PDF

show switch-port-profile

Displays the current and default port profile on a switch.

Syntax
show switch-port-profile node/slot
Parameters
  • node/slot — Enter the switch information. For a standalone switch, enter 1/1.
Default
profile-1
Command Mode
EXEC
Usage Information
A switch-port profile determines the available front-panel ports and breakout modes on Ethernet and unified ports. To display the current port profile, enter the show switch-port-profile command. To reset the switch to the default port profile, enter the no switch-port-profile node/slot command.
Example
OS10(config)# show switch-port-profile 1/1
                                       
                                       |  Node/Unit  |  Current    |  Next-boot  | Default   |
                                       |-------------+-------------------+-------------------|
                                       |     1/1     |  profile-2  |  profile-2  | profile-1 |
                                       
                                       Supported Profiles:
                                       profile-1
                                       profile-2
                                       profile-3
                                       profile-4
                                       profile-5
                                       profile-6
                                    
Supported Releases
10.3.1E or later

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\