OS10 Enterprise Edition User Guide Release 10.4.0E(R3)

PDF

show vlan

Displays VLAN configurations.

Syntax
show vlan vlan-id
Parameters
vlan-id — (Optional) Enter a VLAN ID number (1 to 4093).
Default
Not configured
Command Mode
EXEC
Usage Information
Use this command to view VLAN configuration information for a specific VLAN ID.
Example
OS10# show vlan
                                       
                                       Codes: * - Default VLAN, G-GVRP VLANs, R-Remote Port Mirroring VLANs, P-Primary, C-Community, I-Isolated
                                       Q: A-Access (Untagged), T-Tagged
                                       x-Dot1x untagged, X-Dot1x tagged
                                       G-GVRP tagged, M-Vlan-stack, H-VSN tagged
                                       i-Internal untagged, I-Internal tagged, v-VLT untagged, V-VLT tagged
                                       NUM    Status    Description          Q Ports
                                       *   1      up                                        A Eth1/1/2-1/1/32
                                       A Po40
                                       200    up                             T Eth1/1/3:2
                                       T Po40
                                       A Eth1/1/31
                                       320    up                             T Eth1/1/25:4 1/1/32
                                       T Po40
                                       A Eth1/1/3:1
                                       
                                    
Supported Releases
10.2.0E or later

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\