OS10 Enterprise Edition User Guide Release 10.4.0E(R3)

PDF

source-interface

Configures the interface used to connect to the SupportAssist server.

Syntax
source-interface interface
Parameters
interface :
  • ethernet node/slot/port[:subport] — Enter a physical Ethernet interface.
  • loopback number — Enter a loopback interface (0 to 16383).
  • management 1/1/1 — Enter the management interface.
  • port-channel channel-id — Enter a port-channel ID (1 to 28).
  • vlan vlan-id — Enter a VLAN ID (1 to 4093).
Default
A source interface is not configured.
Command Mode
SUPPORT-ASSIST
Usage Information
The no version of this command removes the configured source interface.
Example
OS10(conf-support-assist)# source-interface ethernet 1/1/4
Supported Releases
10.4.0E(R1) or later

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\