OS10 Enterprise Edition User Guide Release 10.4.0E(R3)

PDF

source-ip

Configures the source, destination, and protocol type of the monitored port for an ERPM monitoring session.

Syntax
source-ip source ip-address destination-ip destination ip-address [gre-protocol protocol-value]
Parameters
  • source ip-address — Enter the source IP address.
  • destination ip-address — Enter the destination IP address.
  • protocol-value — Enter the GRE protocol value (1 to 65535, default: 35006).
Default
Not configured
Command Mode
MONITOR-SESSION
Usage Information
None
Example
OS10(config)# monitor session 10
                                       OS10(conf-mon-erpm-source-10)# source-ip 10.16.132.181 destination-ip 172.16.10.11 gre-protocol 35006
                                       
                                    
Supported Releases
10.4.0E(R1) or later

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\