OS10 Enterprise Edition User Guide Release 10.4.0E(R3)

PDF

source (Port Monitoring)

Configures a source for port monitoring. The monitoring session can be one of the following: local, RPM , or ERPM .

Syntax
source interface interface-type {both | rx | tx}
Parameters
  • interface-type — Enter the interface type:
    • ethernet node/slot/port[:subport] — Enter the Ethernet interface information as the monitored source.
    • port-channel id-number — Enter the port-channel interface number as the monitored source (1 to 128).
    • vlan vlan-id —Enter the VLAN identifier as the monitored source (1 to 4093).
  • both — Monitor both receiving and transmitting packets. This option is not supported in VLAN.
  • rx — Monitor only received packets.
  • tx — Monitor only transmitted packets. This option is not supported in VLAN.
Default
Not configured
Command Mode
MONITOR-SESSION
Usage Information
None
Example
OS10(config)# monitor session 1
                                       OS10(conf-mon-local-1)# source interface ethernet 1/1/7 rx
                                    
OS10(config)# monitor session 5 type rspan-source
                                       OS10(conf-mon-rspan-source-5)# source interface ethernet 1/1/10 rx
                                    
OS10(config)# monitor session 10 type erpm-source
                                       OS10(conf-mon-erpm-source-10)# source interface ethernet 1/1/5 rx
                                    
Supported Releases
10.2.0E or later

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\