OS10 Enterprise Edition User Guide Release 10.4.0E(R3)

PDF

spanning-tree disable

Disables the spanning-tree mode configured with the spanning-tree mode command globally on the switch or on specified interfaces.

Syntax
spanning-tree disable
Parameters
None
Default
Not configured.
Usage Information
The no version of this command re-enables STP and applies the currently configured spanning-tree settings.
Command Mode

CONFIGURATION

INTERFACE

Example
OS10(config)# interface ethernet 1/1/4
                                       OS10(config-if-eth1/1/4)# spanning-tree disable
                                       
                                    
Supported Releases
10.3.0E or later

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\