OS10 Enterprise Edition User Guide Release 10.4.0E(R3)

PDF

spanning-tree vlan disable

Disables spanning tree on specified VLAN.

Syntax
spanning-tree vlan vlan-id disable
Parameters
vlan-id — Enter the VLAN ID number, ranging from 1 to 4094.
Default
Enabled
Command Mode
CONFIGURATION
Usage Information
The no version of this command enables spanning tree on the specified VLAN.
Example
OS10(config)# spanning-tree vlan 100 disable
                                       
                                    
Supported Releases
10.4.0E(R1) or later

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\