OS10 Enterprise Edition User Guide Release 10.4.0E(R3)

PDF

switchport trunk allowed vlan

Configures the tagged VLAN traffic that a L2 trunk interface can carry. An L2 trunk port has no tagged VLAN membership and does not transmit tagged traffic.

Syntax
switchport trunk allowed vlan vlan-id-list
Parameters
vlan-id-list — Enter the VLAN numbers of the tagged traffic that the L2 trunk port can carry. Comma-separated and hyphenated VLAN number ranges are supported.
Default
None
Command Mode
INTERFACE
Usage Information
Use the no version of this command to remove the configuration.
Example
OS10(conf-if-ma-1/1/1)# switchport trunk allowed vlan 1000
OS10(conf-if-ma-1/1/1)# no switchport trunk allowed vlan 1000
Supported Releases
10.2.0E or later

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\